9
EC750
Please Note:
Maximum steam delivery of 60
seconds is recommended and the milk must not
be frothed more than 3 times consecutively.
producInG Hot Water
You can also use this appliance to heat liquids other
than milk, with excellent results.
1. Turn the appliance on by pressing the ON/OFF
button (fig. 4).
2. Pour the water to be heated into the milk tank.
3. Turn the froth regulator to the right (fig. 19)
and place a cup under the milk tube (fig. 17).
4. Wait for the IFD light to come on (fig. 16) then
press the IFD button immediately (fig. 18).
5. When you have run off the required quantity of
water, press the “IFD” button again to interrupt
delivery.
cleanInG
Danger!
Before performing any cleaning
operations of the external parts of the appliance,
switch the machine off, remove the plug from the
socket and let the machine cool down.
cleaning the cappuccino maker
The cappuccino maker must be cleaned each time you
use the appliance. Proceed as follows:
• Lift the milk tank lid.
• With one hand press the release lever towards the
left and at the same time lift the tank up (see fig.
21).
• after removing the milk tank, to reach internal
components, push the locking slide inwards (see
fig. 22).
• Lift the milk frother device (see fig. 22).
NB: the milk frother device lid cannot be lifted unless
the milk tank has been removed.
• Remove the rubber frother.
• Remove and wash with hot water with particular
attention to the four holes in the milk frother device
(see fig. 23.)
Make sure the hole indicated with the letter a is
not blocked. If necessary, clean with a needle. Take
care not to lose the gaskets. To facilitate cleaning of
the milk tube, use the supplied cleaning brush, then
replace all components correctly.
• Replace the milk tank and press down until it clicks
into place. Make sure it is correctly inserted by
pulling the tank gently upwards. It should not lift!
If it is not correctly in place, the device will not work
properly.
cleanInG tHe fIlter Holder for Ground
coffee
About every 300 coffees or when the coffee drips out
of the filter holder or not at all, clean the ground coffee
filter holder as follows:
• Remove the filter from the filter holder.
• Remove the filter cap (fig. 24) by unscrewing in
the direction indicated by the arrow on the cap.
• Remove the frother from the container by pushing
it from the cap end.
• Remove the gasket.
• Rinse all components and clean the metal filter
thoroughly in hot water using a brush (fig. 25).
Make sure the holes in the metal filter are not
blocked. If necessary, clean with a pin (see fig.
26).
• Replace the filter and gasket on the plastic disk as
shown in fig. 27.
Make sure to insert the pin on the plastic disk into
the hole in the gasket indicated by the arrow in fig.
27.
• Replace the resulting assembly in the steel filter
container (fig. 28), making sure the pin is inserted
into the hole in the support (see arrow in fig. 28).
• Finally, screw on the cap.
Failure to clean as described above invalidates the
guarantee.
cleanInG tHe BoIler outlet
about every 300 coffees, the espresso boiler outlet
must be cleaned as follows:
•
Make sure the appliance is not hot and that it is
unplugged from the mains;
• Using a screwdriver, unscrew the screw fixing the
espresso boiler outlet (fig. 29);
• Clean the boiler with a damp cloth (fig. 14);
• Clean the outlet thoroughly in hot water using a
brush. Make sure the holes are not blocked. If
necessary, clean with a pin (fig. 26).
• Rub the boiler outlet while rinsing under the tap,
• Replace the espresso boiler outlet, making sure
the gasket is correctly positioned.
Failure to clean as described above invalidates the
guarantee.
otHer cleanInG operatIonS
1.
Do not use solvents or abrasive cleaning products
to clean the appliance. A soft, damp cloth is
sufficient.
2. Clean the filter holder cup, filters, drip tray and
water tank regularly.
Important:
during cleaning, never immerse
the coffee machine in water. It is an electrical
appliance.
