28
Caution!
The cooking hob becomes very hot
during operation.
Keep children well out of reach.
N.B. When the cooker is not being
used, set the gas knobs to their closed
positions and also close the cock
valve on the gas bottle or the main gas
supply line.
Fig. 3.1
Caution!
Do not cover the hob with aluminium
foils.
NOTE:
The knob and symbols may vary.
Fig. 3.2
LIGHTING GAS BURNERS FITTED
WITH SAFETY VALVE DEVICE
(Semi-rapid and triple ring burners)
In order to light the burner, you must:
1. Push and turn the knob in an
anticlockwise direction up to the
position (maximum rate), push in and
hold the knob until the flame has been
lit (fig. 3.2).
The sparks produced by the lighter
situated inside the relative burner will
light the flame.
In the event that the local gas supply
conditions makes it difficult to light the
burner in
position, try again with
the knob in position.
If there is no main electrical supply,
bring a lighted match close to the
burner.
2. Wait for about ten seconds after the
gas burner has been lit before letting
go the knob (safety device activation
delay).
3. Adjust the gas valve to the desired
position.
If the burner flame should go out for some
reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to
the closed “ ” position,
wait for at least
1 minute
and then repeat the lighting
procedure.
If your local gas supply makes it difficult
to light the burner with the knob set to
maximum, set the knob to minimum and
repeat the operation.