20
LIGHTING GAS BURNERS
FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION
■
Check that the electricity is switched on to allow spark
ignition.
■
Make sure that all controls are turned to “
0
” (off).
■
The gas flow to the burner is controlled by taps with
safety cutout device. If the burner flame should go
out, the safety cut-off valve will automatically stop the
gas flow. The switch for the electric ignition is incorpo
-
rated in the knobs.
■
You control the flow by turning the knob indicator
to line up with the following symbols:
– Symbol
0
: tap closed (burner off)
– Symbol
: High (maximum)
– Symbol
: Low (minimum)
■
To ignite automatically, push the required knob down and turn it to maximum, keeping
the knob down until the burner lights. When the flame is lit, wait for about ten second
with the knob down (safety cut-off activation delay).
■
You can control the temperature by the knob to “High” (maximum) from “Low” (mini-
mum).
■
To switch off, turn the knob clockwise until you hear the safety click.
■
Note that, if you are using a burner at the minimum setting, you turn the knob clockwi-
se past the maximum setting before reaching the off position.
■
Whenever the lighting of the burners is difficult due to peculiar conditions of the gas
features or supply, it is advised to repeat the ignition with the knob on “minimum” po-
sition.
■
If when lighting any of the burners an abnormal flame appears, switch the burner off
and relight using the minimum setting.
■
If the flame is still not correct, turn the burner off and call our Customer Service center
for your nearest Authorized Delonghi Service Agent.
■
In the case of a mains failure light the burner with a match or lighted taper.
Figure 17
Содержание DEF608GW
Страница 2: ...2...
Страница 35: ...35 S F C T A B T S Figure 26a Figure 26b Figure 26c Figure 25a Figure 25b...
