DeLonghi DEF608GW, Инструкция по использованию и уходу

Страница: 11 / 44

11
GAS SUPPLY
■ The connection must be performed by an authorised person according to the relevant
standards.
■ Before connecting the appliance to the gas main, mount the brass conical adaptor
onto the gas inlet pipe, upon which the gasket has been placed (figs. 6a - 6b).
Conical adaptor and gasket are supplied with the appliance (packed with conversion
kit for use with Natural gas or ULPG).
■ This appliance is suitable for use with Natural Gas or ULPG. (Check the “gas type”
sticker attached to the appliance).
■ For Natural Gas models the gas supply is connected to the pressure regulator which is
supplied with the appliance (fig. 6b). Adjust the regulator to obtain a test point pressure
of 1 kPa with the two semi-rapid (SR) burners operating at maximum.
■ For ULPG models the gas supply is connected to the test point adaptor which is sup-
plied with the appliance (fig. 6a) and ensure that the supply pressure is regulated to
2.75 kPa.
■ The connection must be made at the rear of appliance (left or right); the pipe does not
cross the cooker (fig. 7).
■ The inlet not used must be closed off with the cap and sealing gasket supplied.
■ IMPORTANT: Use two spanners to tighten or loosen the connecting pipe (fig. 8).
Gas connection for
ULPG
Gas inlet pipe
Nipple
Gasket
Brass conical adaptor
(Thread tight: use
suitable seal)
Test point adaptor
Test
point
Gas connection for
NATURAL GAS
Gas inlet pipe
Nipple
Gasket
Brass conical adaptor
(Thread tight: use
suitable seal)
Gas regulator
Test
point
Figure 6a Figure 6b