DeLonghi DE30W, Инструкция по установке и обслуживанию

Страница: 4 / 24

4
INSTALLATION
CAUTION:
■
This appliance must be installed in accordance with these installation
instructions, local gas fitting regulations, municipal building codes,
water supply regulations, electrical wiring regulations, AS5601 / AG 601
- Gas Installations and ony other relevant statutory regulations.
■
This appliance shall be only be serviced by authorized personnel.
■
This appliance is to be installed only by an authorised person.
■
Incorrect installation, for which the manufacturer accepts no
responsibility, may cause personal injury of damage.
■
Always disconnect the
appliance
from mains power supply before carrying
out any maintenance operations or repairs.
■
In the room where the
appliance
is installed, there must be enough air to
allow the gas to burn correctly, according to the current local
regulations.
ELECTRICAL REQUIREMENTS
■
The appliance must be connected to the mains checking that the voltage
corresponds to the value given in the rating plate and that the electrical
cable sections can withstand the load specified on the plate.
■
The plug must be connected to an earthed socket in compliance with safety
standards.
■
If the appliance is supplied without plug, fit a standard plug which is
suitable for the power consumed by the appliance.
■
The wires in the power cable are coloured in accordance with the following
code: Green/Yellow = Earth, Blue = Neutral, Brown = Active.
If the colours of the wires in the power cable to the appliance do not
correspond with the coloured markings identifying the terminals in the
junction terminal, proceed as follows:
1.The wire which is coloured green and yellow must be connected to the
terminal marked E (Earth) or coloured Green.
2.The wire which is coloured blue must be connected to the terminal marked
N (Nuetral) or coloured Black.
3.The wire which is coloured brown must be connected to the terminal
marked L (Live) or A (Active) or coloured Red.
■
The appliance must be connected directly to the mains placing a two pole
switch with minimum opening between the contacts of 3 mm between the
appliance and the mains.
■
The power supply cable must not touch the hot parts and must be
positioned so that it does not exceed 50°C above ambient.
■
Once the appliance has been installed, the switch or socket must always be
accessible.
■
If the supply cord is damaged it must be replaced by the manufacturer or it’s
Service Agent or a similarly qualified person in order to avoid a hazard.