DeLonghi DE 302 IB-1, Инструкции по установке и обслуживанию, инструкции по использованию и уходу

Страница: 9 / 28

9
ELECTRICAL REQUIREMENTS
■ The appliance must be connected to the mains checking that the voltage corresponds
to the value given in the rating plate and that the electrical cable sections can withstand
the load specified on the plate.
■ A suitable isolating switch providing full disconnection from the mains power supply
shall be incorporated in the permanent wiring, mounted and positioned to comply with
the local wiring rules and regulations. The isolating switch must be of an approved
type and provide a 3 mm air gap contact separation in all poles (or in all active [phase]
conductors if the local wiring rules allow for this variation of the requirements).
■ The isolating switch shall be easily accessible to the customer with the cooktop installed.
■ The power supply cable must not touch the hot parts and must be positioned so that it
does not exceed 75°C above ambient.
■ To connect the appliance to the mains electricity supply, do not use adapters, reducers
or branching devices as they can cause overheating and burning.
N.B. The connection of the appliance to earth is mandatory.
If the installation requires alterations to the domestic electrical system call a qualified
electrician. He should also check that the domestic electrical system is suitable for the
power drawn by the appliance.
Replacing the power cord (not supplied with the appliance) must be done by a
qualified electrician in accordance with the instructions supplied by the manufacturer
and in compliance with established electrical regulations.
CONNECTION OF THE POWER SUPPLY CABLE
Important! This cooktop must be connected to the electricity supply only by an
authorised person.
To connect the feeder cable to the hob it is necessary to carry out the following operations:
■ Turn the cooktop over and unhook the terminal board cover by inserting a screwdriver
into the two hooks “ A ” (fig. 7).
■ Open the cable gland by unscrewing screw “ F ” (fig. 8), unscrew the terminal screws.
■ The supply cable, of suitable type and section, is connected to the terminal board
following the diagram in fig. 9.
VOLTAGE AND POWER CONSUMPTION
220-240 V 50/60 Hz 3700 W 16.08 A