DeLonghi 132213166, Руководство пользователя

Страница: 12 / 13

17
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING ON
The pre-ground coffee function has been
selected without placing any pre-ground
coffee in the funnel (A4) Place pre-ground coffee in the funnel (fig. 17) or
deselect the "pre-ground" function.
The pre-ground coffee funnel (A4) is
clogged Empty the funnel with the help of a brush as de-
scribed in section “16.8 Cleaning the pre-ground
coffee funnel”.
FLASHING
The machine must be descaled The descaling procedure described in section
“17. Descaling” needs to be performed.
FLASHING
Too much coffee has been used Select a milder taste by turning the dial (B6)
anticlockwise.
The water circuit is empty Turn the steam/hot water dial (A21) to the I posi-
tion until delivery stops, then bring it back to the
0 position. If the alarm occurs while hot water
or steam is being delivered, turn the dial to the
0 position. Turn the steam/hot water dial to the I
position until delivery stops, then bring it back to
the
0 position. If the problem persists, make sure
the water tank (A7) is fully inserted.
ON
The inside of the machine is very dirty Clean the inside of the appliance thoroughly, as
described in section “16. Cleaning”. If the mes-
sage is still displayed after cleaning, contact a
customer service centre.
FLASHING
The infuser (A9) has not been replaced
after cleaning Insert the infuser as described in section “16.9
Cleaning the infuser”.
21. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE REMEDY
The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot
water function).
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made. Before making coffee, rinse the internal
circuits by pressing the
button (B5).
A low coffee temperature is set. Set a higher coffee temperature in
the menu (see section “9. Setting the
temperature”).
→