BEFORE YOU BEGIN
Button Functions
!
Read Button - Reads the percent moisture con-
tent value %MC when the meter is in the
portable mode. Turns the meter on in the
continuous mode.
@
Calibration Check Button - Checks the meter
calibration. Displays the average of up to 100
accumulated readings; displays the highest
stored reading; erases the readings (portable
mode only). Turns the meter off in the continu-
ous mode.
#
Set-Point Decrease Button - Allows you to
decrease the set-point to a lower value.
$
Set-Point Increase Button - Allows you to
increase the set-point to a specific %MC. A
buzzer will alert you if the meter reads higher
than the selected %MC. Also operates the back-
light in the portable mode.
When the battery is replaced, the meter displays its
software version for one second and then turns itself
off. After replacing the battery, you must reset the
meter as described on page 6.
TO USE THE METER IN THE
PORTABLE MODE:
Please read this section carefully. In the portable mode, the
FX-2000 has different functions than in the continuous mode.
CHECK CALIBRATION
h
Remove the probe
from the top of the meter.
h
Press and hold
the read button
!
and check button
@
simultaneously. Meter is in calibration if it displays “12”
(± .2) regardless of the scale setting.
3
FX-2000 B&W manual:FX-2000 B&W manual 50406Q5 12/10/08 8:57 A
www.
.com
1.800.561.8187
