3
• Unplug the power source before cleaning. Wipe the dust on surface with slight damp cloth when cleaning,
DO NOT
get water in the electrical
housing, and be careful not to loosen any cables.
• Check carefully to ensure correct and complete assembly before use.
•
Familiarise yourself with all functions and program settings of the product before first use.
• DO NOT
let children play on the product.
•
Slight noise caused by the V-ribbed belt or brake system will not have any effect on the use of the equipment.
• DO NOT
clean the unit with corrosive or abrasive materials.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
•
If the supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or a similarly qualified person in order to avoid a hazard
and prolong the life of the equipment.
• ALWAYS
make sure there are no hazards in the operating environment. E.g., nothing that will get hooked up on the desk, or stop the desk from
raising or lowering fully.
• Operating environment temperature 0-40°C.
• Keep the original instructions, for future reference.
• ALWAYS
inspect the unit prior to use for fatigue and damage.
• Always be careful with the packaging materials in order to avoid any possible danger, e.g. plastic bag may lead to choking hazard to children.
• Keep the original packaging of the equipment if necessary in case of the future use in transportation.
Step 1
Step 2
Assembly
Install the adjust-
able legs onto the
desk frame
Tighten the eight screws (B) with 4mm hex key.
Connect the lift column leg (3) to the
table frame (1) and tighten the screws
(B) with the hex key (D)
Insert the hexagon drive rod in the leg
into the guide slot in the table frame
Once located rotate the column
leg so that the base plate is
hooked on the fixing bolts.
Installing the desk feet.
Orientate the feet (4) as shown in the illustration and tighten the screws (C)
into the leg column (3) with the hex key (E).
4
3
