dellonda DG5 Скачать руководство пользователя страница 1

Thank you for purchasing a Dellonda product. Manufactured to a high standard, this product will, if used according to these 

instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT:

 PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE 

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR 
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Original Language Version

Refer to 

instruction 

manual

PROPANE GAS PYRAMID PATIO HEATERS 13KW

MODEL NO:

 DG5, DG6

1.   SAFETY

 

9

  

Read the installation, operating and maintenance instructions thoroughly before installing or using this equipment.

 

9

   If there is a smell of gas: shut off the gas to the appliance, extinguish any open flames. If odour continues contact gas supplier.

 

8

  

DO NOT

 store or use petrol or other flammable substances inside the housing of the heater. 

 

8

  

DO NOT

 store or use petrol or other flammable liquids or gases in the vicinity of the heater.

 

8

  

DO NOT

 store a gas cylinder that is not connected for use in the vicinity of this or any other appliance.

 

‰

  

WARNING!

 

DO NOT

 use indoors. For use outdoors or in amply ventilated areas. 

 

An amply ventilated area is one that has a minimum of 25% of the surface area open, see fig.1.

 

(The surface area is the sum of the wall surface.)

 

‰

  

WARNING!

 Not intended to be installed in recreational vehicles and/or boats.

 

‰

  

WARNING!

 Improper installation, adjustment, alteration, service or maintenance can cause injury or 

 

property damage.

 

9

   Installation and repair must be carried out by a qualified person.

 

8

  

DO NOT

 attempt to alter in any way.

 

9

   Wear safety gloves during the assembly process.

 

9

   This product must be installed and the gas cylinder stored in accordance with the local regulations in force.

 

8

  

DO NOT

 obstruct the ventilation holes of the cylinder housing.

 

8

  

DO NOT

 move/transport the appliance when in operation. Shut off the gas cylinder at the regulator before moving.

 

8

  

DO NOT

 move/transport the heater until it has cooled down.

 

9

   Use only the type of gas and the type of cylinder specified by the manufacturer.

 

The LP cylinder used with the patio heater must meet the following size requirements:

 

Diameter 31.8cm x height 58cm, 15kg maximum capacity.

 

9

   Protect the product from strong wind to prevent tilting.

 

9

   Only use on level ground, capable of supporting the weight of the heater and the gas cylinder.

 

8

  

DO NOT

 connect the gas cylinder directly to the appliance without a regulator. Use only the type of gas specified in the instructions.

 

9

   The whole gas system (hose, regulator, pilot or burner) should be inspected for leaks or damage before use and at least annually, by a 

 

suitably qualified person. 

 

9

   All leak testing should be done with an appropriate gas leak detection/soap solution. Never use an open flame to check for leaks, refer  

  to section 6.2.

 

8

  

DO NOT

 use the heater until all connections have been leak tested.

 

9

   Turn off the gas immediately if a gas smell is detected. Turn cylinder valve OFF. If the leak is at the hose/regulator connection tighten  

  the connection and perform another leak test. If bubbles continue appearing contact your supplier. If the leak is at the regulator/   

  cylinder connection disconnect from cylinder, reconnect and perform another leak check. If soap bubbles are still seen, cylinder valve  

  is defective. Return cylinder to its place of purchase. 

 

9

   Keep the ventilation opening of the cylinder enclosure free and clear of debris.

 

8

  

DO NOT

 paint the radiant screen, control panel or top canopy reflector.

 

9

   Control compartment, burner and circulation air passageways of the heater must be kept clean.

 

9

   Turn off gas whilst not in use.

 

9

   LP regulator/hose assembly must be a protected from accidental damage.

 

9

   Any guard removed for servicing/maintenance must be replaced before operation.

 

9

   Keeps adults and children away from the high temperature surfaces, to avoid burns and ignition of clothing.

 

9

   Children should be carefully supervised when they are in the vicinity of the heater.

 

8

  

DO NOT

 hang clothing or other flammable materials on the heater or place them near the heater. 

2.  INTRODUCTION

I

nnovative design of Gas Flame Patio Heater. Contemporary free standing patio heater ideal for both commercial and domestic settings 

including open workshops, boat yards, patios, forecourts, gardens and terraces. Standing at 2.2m tall, when lit the heater produces a real 
flame encompassed by a glass tube and heats the surrounding area.

 

Metal reflector makes sure the heat is directed downwards and outwards. 

Variable heat output controls make it fully adjustable. Features a fully enclosed gas cylinder chamber and safety tip over switch.

fig.1

D

G5, DG6  Issue:6  (3,4,5)  30/06/2021

Wear safety 

gloves during 

assembly

Содержание DG5











Отзывы: