a.
Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
b.
Lift the tape, if present, as necessary to pull the top flex-cable connector away from the display connector.
c.
If an optional camera is present on the computer, lift the tape that holds the camera cable in place on the back of the display panel.
Replacing the Display Panel
1.
Reconnect the cable assembly to the back of the display panel.
2.
Replace the display-panel brackets on the display panel (see
Replacing the Display-Panel Brackets
).
3.
Place the display panel inside the display back cover.
4.
Reconnect the speaker connector.
5.
Reconnect the camera connector (if an optional camera is present).
6.
Replace the M2 x 3-mm ground screw that attaches the display-panel ground wire to the display back cover.
7.
Replace the four M2 x 3-mm screws (two on each side) that connect the display panel to the display back cover.
8.
Replace the display bezel (see
Replacing the Display Bezel
).
Display-Panel Brackets
Removing the Display-Panel Brackets
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the display bezel (see
Removing the Display Bezel
).
4.
Remove the display panel (see
Removing the Display Panel
).
1 back of display-panel cable
assembly
3 tape holding camera cable
in place
5 pull-tab on inverter
connector
2 top flex-cable connector
4 bottom flex-cable connector
CAUTION:
Before you begin the following procedure, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface (such as the back
panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
Содержание XPS M1210
Страница 43: ...Back to Contents Page ...