5. Disassembly and Assembly Procedures
Take a stand base close to the monitor. Fit the two
tabs on the upper part of the stand into the grooves on
the back of the monitor, and then lower the stand so
that the monitor mounting area snaps onto the stand.
Use a protective bag to pack the stand base, then lift
up the monitor to checking the gap between the front
bezel with panel module , then provide power supply
and a video signal to the monitor
, then turn on the
monitor for functionality check.
S17
S18
Use a Philips-head screwdriver to tighten four
screws for locking mechanisms. Stick 1pcs label on
the specific positions as the picture below shown.
(No.1~4 screw size=M4x11; Torque=11
±
1kgfxcm)
S16
2
3
4
1
Paste 1pcs aluminum foil to cover the connectors
as the picture below shown, then move the
assembled rear cover close to the panel unit,
then connect the joystick cable to the connector
of circuit board. Put down the rear cover and
push the rear cover on the positions marked as
the picture below shown for mechanisms
engagement.
S15
2
1
