Replacing the Front I/O Panel
Dell Studio XPS™ 435MT Service Manual
1.
2.
Remove the computer cover (see
).
3.
4.
Remove any expansion cards, if necessary (see
5.
Disconnect the cables connected to the I/O panel from the system board.
6.
Remove the screw that secures the I/O panel to the chassis.
7.
Carefully remove the existing I/O panel from the computer.
8.
To replace the I/O panel, align and slide the I/O panel clamp into the I/O panel clamp slot.
9.
Replace the screw that secures the I/O panel to the chassis.
10.
Connect the cables to the system board.
11.
Replace any expansion cards, if necessary (see
12.
Replace the front panel (see
).
13.
Replace the computer cover (see
14.
Connect your computer and devices to electrical outlets, and turn them on.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly
routed or a disconnected cable could lead to computer problems.
1
I/O panel clamp slot
2
cables
3
I/O panel clamp
4
screw
5
I/O panel
Содержание Studio XPS 435 MT
Страница 12: ...Back to Contents Page ...
Страница 22: ......
Страница 26: ...Back to Contents Page ...