2.
To replace the speaker, route the speaker cables back into position.
3.
Connect the right speaker cable to the connector (SPEAKER_2) on the system board.
4.
Place the speaker in position and replace the four screws that secure the speaker to the chassis.
5.
Replace the processor fan and heat sink (see
Replacing the Heat Sink
and
Replacing the Processor Fan
).
6.
Replace the stand (see
Replacing the Stand
).
7.
Replace the shield (see
Replacing the Shield
).
8.
Replace the computer cover (see
Replacing the Computer Cover
).
9.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Removing the Left Speaker
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the shield (see
Removing the Shield
).
4.
Remove the four screws that secure the speaker to the chassis.
5.
Disconnect the left speaker cable from the connector (SPEAKER_1) on the system board.
6.
Lift the speaker away from the system board.
Replacing the Left Speaker
1.
Follow the procedures in
Before You Begin
.
2.
To replace the speaker, route the cables back into position.
NOTE:
To locate the left speaker, see
Inside View of Your Studio One
.
NOTE:
Make a note of the cable routing before you dislodge the cable.
1
screws (4)
2
speaker cable
Содержание Studio One 19
Страница 10: ...Back to Contents Page ...
Страница 25: ...10 Check the amount of memory RAM listed Back to Contents Page ...
Страница 39: ......
