2 00:00:00:00:00:03 Dynamic Po 100 Active
2 00:00:00:00:00:04 Dynamic Po 10 Active
Usage Information
The following describes the
show mac-address-table count
command shown in the following example.
Line Beginning
With
Description
MAC Entries...
Displays the number of MAC entries learned per VLAN.
Dynamic Address...
Lists the number of dynamically learned MAC addresses.
Static Address...
Lists the number of user-defined MAC addresses.
Total MAC...
Lists the total number of MAC addresses the switch uses.
Example (Count)
Dell# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
Dell#
Related Commands
•
show mac-address-table aging-time
— display MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
Syntax
show mac-address-table aging-time [vlan
vlan-id
]
Parameters
vlan
vlan-id
(OPTIONAL) Enter the keyword
vlan
then the VLAN ID to display the MAC address
assigned to the VLAN. The range is from 1 to 4094.
Command Modes
•
EXEC
•
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
Layer 2
931
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...