Dell S6100, Руководство по настройке

Страница: 181 / 1743

Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced on the E-Series.
Usage Information The
remark
command is available in each ACL mode. You can configure up to 4294967291 remarks for a given IP
ACL and 65536 remarks for a given MAC ACL.
The following example shows the use of the
remark
command twice within CONFIGURATION-STANDARD-
ACCESS-LIST mode. The same sequence number was used for the remark and for an associated ACL rule. The
remark precedes the rule in the running-config because it is assumed that the remark is for the rule with the same
sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)# remark 10 Deny rest of the traffic
Dell(config-std-nacl)# remark 5 Permit traffic from XYZ Inc.
Dell(config-std-nacl)# show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 deny any
Dell(config-std-nacl)#
Related Commands
• show config — display the current ACL configuration.
show config
Display the current ACL configuration.
Syntax show config
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
Access Control Lists (ACL) 181