Parameters
number of polling-
interval
Enter the number of polling intervals. The range is from 0 to 1000. The default value is 10.
Defaults
10
Command Modes
CONFIGURATION (conf-storm-control-pfc)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage Information
The
queue-drop backoff-on-norxpfc polling-count
command is used to remove the queue-drop
state if additional PFCs are not received for the specified number of polling intervals.
Example
Use the
storm-control pfc
command in the configuration mode to enter the ‘storm-control-pfc'
configuration mode. The commands provisioned in this mode are applicable for all the interfaces that have PFC
storm enabled.
Dell(conf)#storm-control pfc
Dell(conf-storm-control-pfc)#queue-drop backoff-on-norxpfc polling-count 20
storm-control pfc in queue-drop-state clear
You can clear the queue-drop state on an interface where the PFC storm has been triggered.
Syntax
storm-control pfc in queue-drop-state clear
Parameters
None
Defaults
None
Command Modes
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6000, S6000–ON, S61000–ON, Z9100–ON.
Usage Information
The
storm-control pfc in queue-drop-state clear
command is used to clear the queue-drop state
on a particular interface where the PFC storm has been triggered.
Example
Dell(conf-if-te-0/24)# storm-control pfc in queue-drop-state clear
show storm-control pfc status
You can view the status of the PFC storm on a stack unit with specific port set.
Syntax
show storm-control pfc status stack-unit {
unit-number
} port-set {
portpipe-number
}
Parameters
unit-number
Enter the stack unit number.
Storm Control
1551
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...