4. Disassembly and Assembly Procedures
S2
4
.1 Disassembly Procedures:
S1
S3
Remove the monitor stand base:
1. Place the monitor on a soft cloth or cushion.
2. Press the stand down to access to the release latch.
3. Use a long screwdriver to press the release latch.
While pressing the release latch, slide out the
stand assembly from the monitor.
Use one hand to press the rear cover, then wedge
your fingers between the rear cover and the middle
bezel on the corners of the top left side to the right
side of the monitor to release the rear cover.
To remove the VESA cover: Press the dimple on the
VESA cover to release it from the back of the display.
Use a Philips-head screwdriver to remove 6pcs
screws for unlocking mechanisms.
(No.1~4 screw size=M4x11; Torque=7 8kgfxcm;
No.5~6 screw size=M4x8; Torque=7 8kgfxcm)
~
~
S4
1
3
2
2
2
3
4
1
5
6
Necessary repair and test equipment:
1. Philips-head screwdriver
Tear off 1pcs acetate tape and then disconnect the
panel lamp cable away from the connector of panel.
Tear off 2pcs aluminum foils, and then disconnect
the function key cable away from the connector of
the board.
S5
Use a Philips-head screwdriver to remove 2pcs
screws for unlocking the bracket with middle bezel, to
remove 2pcs screws for unlocking the bracket with
panel module.
(No.1~2 screw size=M3x4, Torque=3
~4
kgfxcm;
No.3~4 screw size=M3x3.5, Torque=2
~3
kgfxcm )
2
1
4
3
Use a Philips-head screwdriver to remove 18pcs
screws for unlocking the middle bezel.
(No.1~13 screw size=M3x4, Torque=3
~4
kgfxcm;
No.14~18 screw size=M2x3.3, Torque=1
±0.2
kgfxcm)
2
12
1
3
8
6
13
9
7
4
5
11
10
15
14
17
18
16
S6
S7
