4. Disassembly and Assembly Procedures
Take 1pcs power board, then connect 1pcs panel
lamp cable to connect with the power board. Turn
over the power board and put it into the bracket.
Place a bracket chassis base on a protective
cushion, then stick 1pcs Silicon sheet on the position
as the picture below shown.
4
.2 Assembly Procedures:
S2
S1
S3
Take 1pcs interface board, connect 1pcs LVDS cable
and 1pcs lamp cable to the interface board(b.c), then
connect the connective cable to the interface board.
Turn over the interface board and locate it into the
bracket. Use a Philips-head screwdriver to tighten
6pcs screws for locking the circuit board, then locate
the panle lamp cable into the hook of the bracket.
(No.1 screw size=M4x8, Torque=7
±0.5
kgfxcm;
No.2~6 screw size=M3x7.5, Torque=7
±0.5
kgfxcm)
3
4
2
1
5
6
Panel preparation: Take out 1pcs panel module from
the carton, then remove the protective film by tearing
off the tapes, and then examine the panel surface
according to inspection criteria. Turn over the panel,
and then place screen faced down for later
assembling.
S6
Take 1pcs mylar to insert the hooks of the bracket to
cover the power board, then locate the panel lamp
cable into the hook as the picture below shown.
a
b
C
Take 1pcs front bezel, lift up the panel module and
then assemble the front bezel with the panel module
unit.
S4
S5