2. Assign the static IP address 192.168.100.98 to the service computer and the subnet mask 255.255.255.240 for the ethernet
interface that is connected to the DM5500. A default gateway is not required.
a. To set a static IP address on a Windows service computer, perform the following steps.
i.
Open
Control Panel
.
ii. Click
Network and Internet
.
iii. Click
Network and Sharing Center
.
iv. Click the
Change adapter settings
option on the left navigation pane.
v. Right-click the network adapter and select the
Properties
option.
vi. Select the
Internet Protocol Version 4 (TCP/IPv4)
option.
vii. Click the
Properties
button.
viii. Select the
Use the following IP address
option.
ix. Assign the static IP address - 192.168.100.98.
x. Specify the subnet mask - 255.255.255.240.
xi. Specify a default gateway - not required.
xii. Under the
Use the following DNS server addresses set Preferred DNS server
section, set the
Preferred DNS
server address
, usually your router's IP address or server IP address providing DNS resolutions.
xiii. (Optional) Specify an
Alternative DNS server
, which the computer will use if it cannot reach the preferred DNS
server.
xiv.Click
OK
.
b. To set a static IP address on a Mac service computer, perform the following steps.
i.
From the Apple menu, select
System Preferences
.
ii. Select
Network
.
iii. From the sidebar, select an active network interface.
iv. Make a note of the current IP address assigned to your Mac. You'll need to select a new IP address from within the
private IP address range listed.
v. Click
Advanced
.
vi. Select
TCP/IP
.
●
In the
Configure IPv4
field drop-down menu, select
Manually
.
●
In the
IPv4 Address
field, enter the 192.168.100.98 static IP address.
●
In the
Subnet Mask
field, enter 255.255.255.240
vii. Click
OK
.
viii. Click
Apply
.
3. Open the command prompt on the service computer and ping the 192.168.100.100 management IP address and verify you
can reach it.
4.
Log in to the Data Manager Appliance Configuration UI
Pre-configuration tasks
41
