Dell PowerEdge 2900, Руководство по установке

Страница: 13 / 110

Rack Installation Guide
11
Configuring the Sliding Rail Assemblies
The rotating mounting brackets on the mounting rails allow you to configure them as either RapidRails
or VersaRails. The mounting-bracket flange on the RapidRails configuration has two hooks and a push
button (see Figure 1-5). The mounting-bracket flange on the VersaRail has three holes (see Figure 1-6).
NOTE:
The rack kit ships with the sliding rail assemblies in the RapidRails configuration.
To rotate the mounting bracket and change the mounting rails from RapidRails to VersaRails
(see Figure 1-4):
1
Lift the release lever on the rotating mounting bracket.
2
Rotate the bracket and slide it up off the two shoulder standoffs.
3
Continue to rotate the bracket 180 degrees until you can set the notches back over the shoulder
standoffs.
4
Rotate the bracket back in the opposite direction on the shoulder standoffs until the bracket clicks
into place.
Figure 1-4. Rotating the Mounting Bracket
1 rotating mounting bracket 2 mounting-bracket flange
(RapidRails version shown) 3 release lever
4 mounting rails 5 shoulder standoff 6 notch
1
2
5
6
4
3