Dell PowerEdge 1955, Руководство по настройке

Страница: 32 / 206

30
General System Configuration
Configuring the Switch Using a Serial or Telnet Console
To configure the Cisco Catalyst Blade Switch 3030 switch module using the DRAC/MC module,
perform the following steps.
1
Log on to the DRAC/MC Telnet or serial interface.
2
To redirect the switch console through the DRAC/MC console, enter the following command:
connect switch- x
where x is the module slot number on the chassis. For example, if you are connecting to
switch module 1, type
connect switch-1
3
Enter privileged EXEC mode:
switch-1 >
enable
4
C
onfigure the number of Telnet sessions (lines), and enter line configuration mode
:
switch-1#
line vty 0 15
5
If applicable, enter a Telnet password :
switch-1#
password password
6
Change to
terminal configuration mode
:
switch-1#
configure terminal
7
Change to
interface configuration mode, and enter the VLAN number to which the IP
information is assigned. The default value is 1
.
switch-1(config)#
interface vlan
vlan-id
8
Specify the IP address and subnet mask:
switch-1(config-vlan)#
ip address ip-address subnet-mask
9
Return to global configuration mode :
switch-1(config-vlan)#
exit
10
Specify the IP address of the default gateway:
switch-1(config)#
ip default-gateway
ip-address
11
Return to
privileged EXEC mode
:
switch-1(config)#
end
12
V erify the IP address:
switch-1 #
show interfaces vlan vlan-id
13
Enter the following command to verify the
default gateway IP address
:
switch-1 #
show ip redirects