W-ClearPass 500 Hardware Installation Guide
10
6B. 2-Post Rack Installation
Unpack the appliance and locate the mounting hardware
Step 1
•
Remove the inner fixed chassis rails from the outer fixed
chassis rails.
•
Pull each one out as far as possible.
•
Depress the locking tab to pull the inner rail completely out.
•
Put these rails aside for later installation on the appliance.
Step 2
•
Attach the long fixed (
A
) and the small (
B
) brackets to the
2-post rack.
•
Mount the short brackets in the front, and the longer brackets in
the back using two M5 x 12
*
flat head screws and cone washers for
each bracket as shown, using the top and bottom holes.
•
Make sure the brackets and screws are aligned in the rack not only
in the front and back, but are level in height on the left and right
sides for proper alignment to allow accurate appliance installation.
Step 3
•
Slide each of the outer fixed chassis rails into the
left and right fixed brackets and loosely secure with
four M4 x 4 truss head screws on each side (shown
with red dotted lines).
•
Leave enough of the outer fixed rails extended in the front
to attach fixed rack brackets (
C
) to the rack rails using two
M4 x 4 truss head screws on each side (shown with the blue
dotted lines). There should be approximately one inch of
space between brackets (
B
) and (
C
) in the front.
•
Once all screws are in place, tighten each one to secure
the outer fixed chassis rails in place.
Once you have completed mounting the brackets and outer fixed chassis rails to the 2-post rack,
proceed to
Section 7
on page 10,
Rail Installation on the Appliance.
NOTE:
Use the hardware supplied with
your specific rack if different from the
hardware supplied in this kit.
*
Содержание Powerconnect W-ClearPass Hardware Appliances
Страница 1: ...W ClearPass 500 Hardware Installation Guide ...
Страница 13: ......
