PowerConnect 3424/3448 Release Notes
System Firmware Version 2.0.0.20
Subject to Change Without Notice
Page 4
Documentation updates
Introduction
This document lists the changes from the PowerConnect 3424/3448 Systems User’s Guide. The modifications are
due to instances discovered in various user environments.
Corrections and Additions to the System Information Guide
Dell PowerConnect 34xx Systems Information Update provides updated installation and configuration information
that replaces part of the installation and configuration information in the Dell PowerConnect 34xx Systems User’s
Note: The phrase “the device” herein after is used to refer to the PowerConnect 34xx Series switches.
Corrections and Additions to the User’s Guide and CLI Reference
Guide
Corrections and Additions to the User’s Guide
Web Screen / Section in Guide
Description of Change
Configuring Switch Information ->
Configuring VLANs -> Defining
VLAN Ports Settings
(RN34666)
* A port can only be assigned to "dynamic VLAN" if it is not a member of
any VLAN except the default VLAN.
* A port can be assigned to "dynamic VLAN" only if it is in access mode.
Note that the default port mode for all ports is "access".
Configuring Switch Information
Æ
Configuring Network Security
Æ
Configuring Port Security
In order to configure traps, the interface must be set to "locked".
Configuring Switch Information
Æ
Configuring VLANs
Æ
Defining VLAN Membership
Æ
Defining VLAN Port Settings
Æ
Defining VLAN LAG Settings
When an interface in General Mode is configured with a PVID, this
interface is not automatically added as a member of the VLAN with that
VID.
Viewing Statistics
Æ
Viewing
RMON Statistics
Æ
Viewing RMON
Statistics Group
Oversize Packets
– Number of oversized packets (over 1632 octets)
received on the interface since the device was last refreshed.
Jabbers
– The number of packets received during this sampling interval
that were longer than 1632 octets (excluding framing bits but including
FCS octets), and had either a bad Frame Check Sequence (FCS) with an
integral number of octets (FCS Error) or a bad FCS with a non-integral
number of octets (Alignment Error).
Dropped Events
– counter is not supported.
(and not as indicated)
