Dell POWER VAULT 130T LIBRARY 130T, Руководство по обслуживанию, Страница: 57 / 96

PowerVault 130T Service Manual
Electronics Module
4473D
3–21
Figure 3–7. Electronics Module (and CYC card) showing Cable Locations
10. Reaching into the access door, disconnect J17, J25, J31, J37 and J39 cables from their
connectors on the CYC card. (The CYC card is the large controller card mounted to the
electronics module.) Use a flashlight to see, if necessary.
NOTE: The connectors are different and are therefore removed differently. For example,
connector J37 requires that you loosen its thumbscrews before you can remove it. Some
connectors require you to pinchtabs together or push tabs apart.
11. Disconnect the tape drive power cables from the electronics module power receptacles.
CAUTION: Failure to disconnect all the cables described above will cause cable
damage and possibly card connector damage when you slide out the electronics
module. When the cables are disconnected, take care not to snag them on the
electronics module when you slide it out.
12. Slide the electronics module out of the library, verifying that all cables are disconnected.
13. Place the damaged electronics module on a flat, stable surface.
WARNING: Do not apply power to the electronics module assembly when it is not
installed in the PowerVault 130T. (Refer to S04 in the Safety Booklet.)