37
| Configuring a Stateful HA Pair
Configuring a Stateful HA Pair
This section provides instructions for configuring a pair of Dell
SonicWALL NSA E5500 appliances for high availability (HA).
This section is relevant to administrators following deployment
Scenario B
.
This section contains the following sub-sections:
•
Initial High Availability Setup
- page 37
•
Configuring High Availability
- page 38
•
Configuring Advanced HA Settings
- page 38
•
Configuring HA Monitoring Settings
- page 40
•
Synchronize Settings
- page 40
•
HA License Configuration Overview
- page 42
•
Associating Pre-Registered Appliances
- page 43
•
Configuring L2 Bridge Mode
- page 43
Initial High Availability Setup
Before you begin the configuration of HA on the Primary Dell
SonicWALL security appliance, perform the following setup:
• On the bottom panel of the secondary Dell SonicWALL
security appliance, locate the serial number and write the
number down. You need to enter this number in the
High
Availability
>
Settings
page.
• Verify that the primary and secondary Dell SonicWALL
security appliances are registered, running the same
SonicOS versions.
• Make sure the primary and secondary Dell SonicWALL
security appliances’ LAN, WAN and other interfaces are
properly configured for failover.
• Connect the HA ports on the primary and secondary Dell
SonicWALL appliances with a CAT6-rated crossover cable
(red crossover cable). The primary and secondary Dell
SonicWALL security appliances must have a dedicated
connection using the HA interface. Dell SonicWALL
recommends cross-connecting the two together using a CAT
6 crossover Ethernet cable, but a connection using a
dedicated 100Mbps hub/switch is also valid.
SonicWALL NSA E-Class 1
SonicWALL NSA E-Class 2
HA
HA
X0
X1
X1
X0
E5500
Network Security Appliance
E5500
Network Security Appliance
Local Network
SonicWALL
HA / Failover Pair
Internet
HA Link
Содержание NSA E5500
