Version 8.3.7.0
Introduced on the S4810.
Usage
Information
Use the default pre-defined profiles or configure your own profile. You cannot
delete the pre-defined profiles or their default values. This command enables
WRED configuration mode —(conf-wred).
Related
Commands
— specifies the minimum and maximum threshold values of the WRED
profile.
rate shape
Define the rate-shaping method to be either as a measure of bytes or packets for each of the hierarchical
QoS (HQoS) nodes at the leaf level to be applied to each queue.
S6000
Syntax
[no] rate-shape [kbps | pps] peak-rate [
burst-KB/Packets
]
[committed [kbps | pps] committed-rate [
burst-KB/Packets
]]
Parameters
kbps
Enter the keyword kbps to specify the committed rate limit in
Kilobits per second (Kbps). Specify this value as a multiple of
64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
pps
Enter the keyword pps to specify the committed rate limit in
packets per second (pps). The range is from 1 to 268000000.
The default granularity is Megabits per second (Mbps).
committed-
rate
Define the committed rate, which is the guaranteed or
minimum confirmed rate for the packets. Specify this value
as a multiple of 64 if you specify the committed rate in Kbps.
The range is from 0 to 40000000 for Kbps. The range is
from 1 to 268000000 for pps. The range is from 0 to 40000
for Mbps (which is the default measure for rate limits if you
do not explicitly configure Kbps or pps)
burst-KB
(OPTIONAL) Enter the committed burst size in KB. The range
is from 0 to 10000. The default is 50 KB. The default peak
burst is regarded as the same value as the configured
committed burst size.
Packets
(OPTIONAL) Enter the committed burst size as a count of
packets. The range is from 1 to 1073000. The default is 50
packets. The default peak rate is regarded as the same value
as the configured committed rate.
peak-rate
Define the peak rate, which is the guaranteed or minimum
confirmed rate for the packets. Specify this value as a
multiple of 64 if you specify the peak rate in Kbps. The range
is from 0 to 40000000 for Kbps. The range is from 1 to
268000000 for pps. The range is from 0 to 40000 for Mbps
(which is the default measure for rate limits if you do not
explicitly configure Kbps or pps)
Quality of Service (QoS)
1151
Содержание Networking S6000 System
