Dell Networking S6000 System, Справочное руководство

Страница: 1120 / 1510

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a
maximum of five ACL match criteria are allowed. For
class-map match-all
,
only one ACL match criteria is allowed.
Related
Commands
class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
S6000
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value ]
To remove a DSCP value as a match criteria, use the
no match {ip | ipv6 |
ip-any} dscp dscp-list [[multicast] set-ip-dscp value ]
command.
Parameters
ip Enter the keyword
ip
to support IPv4 traffic.
ipv6 Enter the keyword
ipv6
to support IPv6 traffic.
ip-any Enter the keyword
ip-any
to support IPv4 and IPv6 traffic.
dscp-list Enter the IP DSCP values that is to be the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 63.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command
Modes CLASS-MAP CONFIGURATION (config-class-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
1120
Quality of Service (QoS)