Dell Networking S5000, Руководство по началу работы

Страница: 43 / 346

Navigate CLI modes
The FTOS prompt changes to indicate the CLI mode. You must move linearly through the
command modes, except for the
end
command which takes you directly to EXEC
Privilege mode and the
exit
command which moves you up one command mode level.
Default Configuration
A version of FTOS is preloaded onto the S5000; however, the system is not configured
when you power up for the first time (except for the default host name, which is
FTOS
).
You must configure the system using the CLI.
Configuring Layer 2 (Data Link) Mode
To enable Layer 2 data transmissions through an individual interface, use the
switchport
command in INTERFACE mode. You cannot configure switching or Layer
2 protocols, such as spanning tree protocol (STP), on an interface unless the interface
has been set to Layer 2 mode.
1. Enable the interface.
INTERFACE mode
no shutdown
2. Place the interface in Layer 2 (switching) mode
INTERFACE mode
switchport
To view the interfaces in Layer 2 mode, use the
show interfaces switchport
command in EXEC mode.
Accessing the System Remotely
You can configure the system to access it remotely by Telnet.
The system has a dedicated management port and a management routing table that is
separate from the IP routing table.
1. Configure an IP address for the management port (refer to Configuring the
Management Port IP Address
).
2. Configure a management route with a default gateway (refer to
Configuring a
Management Route
).
41