101-00348-05
|
3
Line Card Hardware/Software Requirements
Line Card LED Description
Figure 1-7. ExaScale 4-port 40G line card
NOTE:
The 4-port 40G line card protrudes from the chassis front by approximately 2 inches. Do not force the
card flush to the chassis front when installing. The locking levers will secure the card when it is seated in the
backplane.
NOTE:
•
The following FTOS features are NOT supported on the 4-port 40G line card (LC-EH-40GE-4P,
LC-EJ-40GE-4P): Ipv6 MultiCast, Non-default CAM profiles, BFD, PBR, Flow, VLAN Stacking; QOS, CFP
Optics. Installing the line card in a system running these features can lead to unpredictable behavior.
Table 1-1. ExaScale Line Card Hardware/Software Requirements
Catalog Number
Description
Hardware Requirements
Minimum FTOS
Version
10 port 10GE line card with XFP optics (10M
CAM)
LC-EH-10GE-10P
XFP optics are required
8.3.1.0
10 port 10GE line card with XFP optics (40M
CAM)
LC-EJ-10GE-10P
XFP optics are required
8.3.1.0
10 port 10GE line card (10M CAM)
LC-EH-10GE-10S
SFP+ optics are required
8.1.1.1
10 port 10GE line card (40M CAM)
LC-EJ-10GE-10S
SFP+ optics are required
8.1.1.1
40 port 10GE line card with SFP+ optics
(10M CAM)
LC-EH-10GE-40S
SFP+ optics are required
8.3.1.2
40 port 10GE line card with SFP+ optics
(40M CAM)
LC-EJ-10GE-40S
SFP+ optics are required
8.3.1.2
50 port 1GE line card (10M CAM)
LC-EH-GE-50P
—
8.3.1.0
50 port 1GE line card (40M CAM)
LC-EJ-GE-50P
—
8.3.1.0
90 port 1GE line card (10M CAM)
LC-EH-GE-90M
requires MRJ21 cables
8.1.1.2
90 port 1GE line card (40M CAM)
LC-EJ-GE-90M
requires MRJ21 cables
8.1.1.2
Label
Description
Port
L/A:
Blinking Green: Link detected/ Activity
Solid Green: Link detected/ No Activity
Off: No Link/ Card Offline
Status LED
Green: operational
Red: card problem state
Flashing green: booting/ diagnostics
Unlit: in standby mode or power is off
