Dell Latitude 5430, Руководство по обслуживанию

Страница: 60 / 110

Steps
1. Remove the two (M2x3) screws that secure the eDP cable bracket to the system board.
2. Lift the eDP cable bracket away from the computer.
3. Peel the tape that secures the display cable to the system board.
4. Using the pull tab, disconnect the display cable from the connector on the system board.
5. Disconnect the eDP cable from the connector on the system board and unroute it from the routing guide.
6. Peel the adhesive tape partially and unroute the antenna cables from the routing guides on the system board.
7. Open the display assembly to a 180 degree and flip over the computer, and then place the computer on a flat surface.
8. Remove the four (M2.5x5) screws that secure the display hinges to the system board.
9. Remove the display assembly off the computer.
Installing the display assembly
Prerequisites
Om du byter ut en komponent, ta bort den befintliga komponenten innan du utför installationsproceduren.
About this task
The following image indicates the location of the display assembly and provides a visual representation of the installation
procedure.
60 Ta bort och installera komponenter