b Lift the heat sink away from the laptop [2].
NOTE:
Ensure to loosen the screws diagonally. The screws cannot be removed completely as being retention screws.
Installing the heat sink
1
Place the heat sink on the system board.
2
Tighten the captive screws to secure the heat sink to the laptop.
NOTE:
Ensure to tighten the screws diagonally to evenly cover the processor. Start with a screw and proceed with
diagonally opposite screw, irrespective of which screw one starts with.
3
Install the:
a
b
4
Follow the procedure in
After working inside your computer
.
LED board
Removing the LED board
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
To remove the LED board:
a Lift the latch and disconnect the LED board cable [1].
NOTE:
Use a sharp tool or a plastic scribe to gently lift the latch.
22
Removing and installing components
