4
Version B - Adding an Extra Drive
This guide assumes that you are keeping the old Drive installed (e.g. to be used for data
storage). If you are not keeping the old Drive in the Computer, or if the Computer does
not have a spare Drive Bay or SATA Connection to install both old and new Drives at the
same time, please follow Version A on Page 2
1
–
Make sure the computer is
completely shut down and switched off.
2
–
Unplug every cable from the
Computer, making a note of which cable
goes where.
3
–
Remove the outer casing. This is
normally done by removing the screws
that hold it in place.
4
–
Attach the 2.5” to 3.5” Mounting Brackets
to the SSD by aligning the Mounting Screw
Holes on the Brackets with those on the SSD
and inserting the M3 Flat Head Screws.
5
–
Locate an available
2.5”/3.5” Bay inside
the Computer and install the SSD using the
Screws.
NB
–
Your system may require proprietary chassis screws, rails or a bracket system to be
used with its Drive Bay(s). In this case, please attach that hardware to the 2.5” to 3.5”
Mounting Bracket
for compatibility with the Computer’s Chassis.
