Dell EMC VNXe Series, Руководство по аппаратным средствам

Страница: 29 / 52

System component description
29
Overview
The two-port 10-Gb/s copper Ethernet (RJ-45) ports on the two-port 10-Gb/s copper
Ethernet I/O personality module are LAN ports not WAN ports. LAN ports contain safety
extra-low voltage (SELV) circuits, and WAN ports contain telephone-network voltage (TNV)
circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when
connecting cables. To avoid electric shock, do not connect TNV circuits to SELV
circuits.
Figure 14 shows an example of the VNXe3150 platform SP optional two-port
10-Gb/s copper Ethernet personality module. The ports are labeled e0 and e1 and are
used for front-end connectivity. These ports support speeds up to 10-Gb/s Ethernet
transmission rates over copper wiring.
Figure 14 Two-port 10-Gb/s copper Ethernet I/O personality module LEDs
Table 8 describes the SP optional 10-Gb/s copper Ethernet personality module fault and
port LEDs.
IMPORTANT
The ports shown in Figure 14 are LAN ports. A symbol depicting a telephone handset with
a line through it indicates that you should not connect WAN type RJ-45 telephone
connectors to these ports.
To access the Ethernet ports, connect a Category 6 unshielded twisted-pair (UTP) cable to
the RJ-45 connectors on the back of the SP 1-Gb/s copper Ethernet personality module, as
described in
Table 7 on page 28 .
e0 e1
Personality card fault LED
Activity LED
Link LED
10 GbE BaseT
VNXe-000124
Table 8 10-Gb/s copper Ethernet personality module fault and port LEDs
LED Color State Description
Fault Amber On Fault, replace personality module
Activity, left Amber Blinking Transmit/receive activity
— Off No activity
Link, right Green On Network/link connection (any speed)
— Off No network/link connection