System component description
21
Overview
AC power supply/cooling module
shows an example of the AC power supply module with a power in
(recessed) connector (plug) and status LEDs. The SP is cooled by this power supply
located on the top portion of the 2U DPE. The power supply/cooling module has a
separate latch handle located on the top, middle portion of the module. Typically, this
power supply/cooling module stays plugged into the 2U DPE when the SP is removed.
Figure 9 AC power supply/cooling module power in (recessed) connector (plug) and status LEDs
describes the power supply/cooling module LEDs.
SP
shows an example of the VNXe3100 platform SP. The SP has an Intel
Xeon dual core 1.73-GHz processor with two Double Data Rate Three (DDR3) synchronous
dynamic RAM (SDRAM) slots supporting 4 GB of memory per processor or optional 8 GB
per processor.
The SP connectors, LEDs, and other components are:
• USB
• Two 1-GbE iSCSI (host IP connect) ports
• Two 6-Gb/s SAS x4 ports (labeled 6Gb SAS 0 x4 and 1 x4)
Note: 6Gb SAS port 1 x4 is not used at this time.
1
Fan fault LED
Power supply in
Power on LED
Fault LED
VNX-000083
Table 2 AC power supply module/cooling LEDs
LED
Color
State
Description
Power on
Green
On
Power on
—
Off
Power off
Power fault
Amber
On
Power supply fault
Blinking
Power off due to environmental condition (no SP
inserted)
—
Off
No fault or power off
Fan (blower)
fault
Amber
Fault
Fault, not operating normally
—
Off
No fault, fan operating normally