Figure 71. Removing filler bracket from Riser 1
3. Hold the card by the edges, and align the card edge connector with the expansion card connector on the riser.
4. Insert the card edge connector firmly into the expansion card connector until the card is fully seated.
5. Rotate and close the card holder and side card holder.
6. Push the side holder and ensure that the latch hook holds the riser cover.
Figure 72. Installing expansion card in Riser 1
NOTE:
The blue retention latch is only used when a half-length card is installed. If a shorter card is installed the blue
retention latch is not applicable.
7. For Riser 2 and 3, to remove the filler bracket remove the screw using Phillips 2 screwdriver.
Installieren und Entfernen von Systemkomponenten
79
