4.
From the outside of the computer, pull the insert away from the computer's front panel.
5.
Remove the insert from the insert frame by pressing on the four tabs.
6.
Reattach the empty insert frame over the front of the drive bay.
The insert frame fits only one way.
a.
Face the front of the computer and slip the left side of the insert in to the left side of the drive bay opening.
b.
Slightly press the right-side insert release tab and gently push in the insert.
If you are adding a floppy drive and you purchased the drive from Dell, you received a front panel insert in your floppy drive kit. Attach this insert over the front
of the drive bay.
If you are adding a floppy drive that was not purchased from Dell, reattach the empty insert frame over the front of the drive bay.
Floppy Drive
Follow the procedures in "
Before You Begin
."
Removing a Floppy Drive
1.
Disconnect the power and data cables from the back of the floppy drive.
2.
Disconnect the other end of the data cable from the system board.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide
.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTE:
If you are adding a floppy drive, see "
Installing a Floppy Drive
."
