Basic Troubleshooting
2-5
4. Verify that all jumpers are set correctly.
For information about these jumpers, see “System Board Jumpers” in Chap-
ter 1.
5. Check all cable connectors inside the computer to verify that they are
firmly attached to their appropriate connectors.
6. Reinstall the computer cover.
7. Reconnect the computer and any attached peripherals to their power
sources, and turn them on.
Does the problem appear to be resolved?
Yes.
No further steps are necessary. Terminate the procedure.
No.
Proceed to the next section, “Eliminating Resource Conflicts,” and to
“Getting Help” found later in this chapter.
E
liminating Resource Conflicts
Devices within the computer may require dedicated memory spaces, interrupt
levels, or DMA channels, all of which must be allocated during installation of
the devices. Because a device may be installed at a different time, it is possible
that the same resource is assigned to two or more devices.
Resource conflicts can result in disorderly or erratic system operation or failure
of the system to operate at all. If you suspect that resource conflicts might exist,
check the system and reassign the resources as necessary.
R
unning the System Diagnostics
The system diagnostics (included on the
Dell Server Assistant
CD) contains
tests that aid in troubleshooting all major components of the computer system.
To start the diagnostics, insert the CD into the CD-ROM drive, and then press
the reset button on the computer.
Restarting the computer causes the Dell Server Assistant logo screen to appear
on the monitor screen, followed by a screen containing icons of the options
available. Selecting the Run System Utilities icon brings up a screen with the
diagnostics icon. Before the Dell Server Assistant loads, a program tests the
portion of main memory (RAM) required for loading the diagnostics. If a main
memory error is detected, a message telling you which DIMM has failed
appears on the screen.
