Dell 7330, Руководство пользователя

Страница: 35 / 229

Configuring the Network Address
Dell 7330 Mono Laser Printer
3-6
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
■
DHCP (enabled by default)
■ AutoIP
You can turn on/off both protocols using the control panel, or use the Embedded Web Server to
turn on/off DHCP.
Note: You can view the printer’s IP address at any time. On the control panel, select
Information
, press the OK button, select
Printer Identification
, and then press the
OK button.
Using the Control Panel
To turn on/off either the DHCP or AutoIP protocol:
1. On the control panel, select
Printer Setup
, and then press the OK button.
2. Select
Connection Setup
, and then press the OK button.
3. Select
Network Setup
, and then press the OK button.
4. Select
TCP/IPv4 Setup
, and then press the OK button.
5.
Select DHCP/BOOTP or AutoIP .
6. Press the OK button to turn the selection
On
or
Off
.
Using the Embedded Web Server
To turn on/off the DHCP protocol:
1. Launch your web browser.
2. Enter the printer’s IP address in the browser’s Address field.
3.
Select Properties .
4. Select the Protocols folder on the left navigation panel.
5. Select TCP/IP .
6.
Click the TCP/IP (v4) button.
7. In the BOOTP/DHCP Settings section, set the BOOTP/DHCP option to On or Off .
8. In the TCP/IP Settings section, enter the static IP address which may be different than the
DHCP or auto IP address listed. Check that the Network Mask and Router/Gateway
address are correct for your network.
9. Click the Save Changes button.