Optional internal USB memory key
Replacing the optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in
on page 66.
2. Follow the procedure listed in
Before working inside your system
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the
System board jumpers and connectors
.
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1. Follow the procedure listed in
Before working inside your system
2. While booting, press F2 to enter
System Setup
and verify that the system detects the USB memory key.
Control panel assembly
Removing the control panel assembly
Prerequisites
1. Follow the safety guidelines listed in
on page 66.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the cooling fan assembly
Steps
1. Using the Phillips #2 screwdriver, remove the screw that secures control panel to the chassis.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION:
Do not use excessive force when removing the control panel cables as it can damage the
connectors.
3. Slide the control panel out of the chassis.
NOTE:
Follow the same steps to remove the control panel in the rack-mode configuration.
148
Installing and removing system components
Содержание 5WC10
Страница 21: ...Figure 16 Configuration and layout Dell EMC PowerEdge T640 overview 21 ...
Страница 22: ...Figure 17 Electrical overview 22 Dell EMC PowerEdge T640 overview ...
Страница 23: ...Figure 18 Memory information Dell EMC PowerEdge T640 overview 23 ...
Страница 24: ...Figure 19 System tasks 24 Dell EMC PowerEdge T640 overview ...
