Dell EMC Precision 7750, Руководство по обслуживанию

Страница: 91 / 103

Steps
1. Peel the adhesive tape that covers the camera module.
2. Disconnect the display cable from the camera module.
3. Gently pry the camera shutter cap from the top edge of the camera shutter and remove it from the display back cover.
4. Gently pry the camera module from the display back cover.
Installing the camera
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the camera and provides a visual representation of the installation procedure.
Steps
1. Place the camera module in its slot on the display back cover.
2. Place the camera shutter cap on the top edge of the camera shutter.
3. Connect the display cable to the camera module.
4. Adhere the adhesive tape to cover the camera module.
Next steps
1. Install the display panel .
2. Install the display bezel .
3. Install the speaker .
4. Install the display assembly .
5. Install the system board .
6. Install the GPU card .
7. Install the GPU power cable .
8. Install the inner frame .
9. Install the heat-sink assembly .
10. Install the primary memory .
11. Install the keyboard .
12. Install the keyboard lattice .
Desmontaje y reensamblaje 91