2. Follow the procedure listed in
After working inside your system
3. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
3.
.
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
2. Disconnect the serial COM port cable from the serial port.
Figure 75. Removing the serial COM port
Next steps
1.
.
Installing and removing system components
97
