Figure 83. Removing the system battery
2. To install a new system battery:
a) Hold the battery with the positive side facing up and slide it under the securing tabs.
b) Press the battery into the connector until it snaps into place.
Figure 84. Installing the system battery
Next steps
1.
Install the expansion card risers
2. If applicable, connect the cables to one or more expansion cards.
3. Follow the procedure listed in
After working inside your system
4. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup
Time
and
Date
fields.
c.
Exit
the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see Getting help section.
Installing and removing system components
105
