Card
description
Card type
Maximum
allowed
Slot
Priority
Slot width
Link width
Card width Card length
Card height
BOSS2 card
Internal
Storage
1
2
x16
x8
SW
HL
FH
1
1
x8
x4
SW
HL
LP
1G Network
card
NIC: 1Gb
1
2
x16
x8
SW
HL
FH
1
1
x4
x4
SW
HL
LP
1
1
x8
x4
SW
HL
LP
Removing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in the
Before working inside your system
.
3.
Steps
1. Open the blue expansion card riser retention-latch located on the system.
2. Holding the blue touch points, lift the expansion card riser from the system.
Figure 37. Removing the expansion card riser
3. If you are not replacing the expansion card riser, install a expansion card riser filler bracket by performing the following steps:
a) Align the expansion card riser filler bracket with the slot on the system.
b) Push the expansion card riser filler bracket downward until firmly seated.
c) Close the blue expansion card retention latch by pushing the latch down until the latch snaps into place.
d) Using a Phillips #2 screwdriver, tighten the screw to secure the expansion card riser filler to the chassis.
4. Using a Phillips #2 screwdriver, fasten the screw to secure the expansion card riser filler to the chassis.
60
PowerEdge R340 installing and removing system components