Figure 66. Cabling the 12 x 3.5 inch backplane
1
backplane
2
SATA cable for sled 1(BP: SATA cable sled 1 to left linking
board)
3
signal cable sled 1(BP: BP_SIG1 to left linking board)
4
linking board connector for sled 1
5
left linking board
6
linking board connector for sled 2
7
SATA cable for sled 2(BP: SATA cable sled 2 to left linking
board)
8
signal cable sled 2(BP: BP_SIG2 to left linking board)
9
SATA cable for sled 3(BP: SATA cable sled 3 to right linking
board)
10
signal cable sled 3(BP: BP_SIG3 to left linking board)
11
right linking board
12
linking board connector for sled 3
13
linking board connector for sled 4
14
SATA cable for sled 4(BP: SATA cable sled 4 to right linking
board)
15
signal cable sled 4(BP: BP_SIG4 to left linking board)
Control panel
Removing the control panel
Prerequisites
NOTE:
Observe the routing of the cables on the enclosure as you remove them. You must route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1
Follow the safety guidelines listed in
Safety instructions
.
2
Follow the procedure listed in
Before working inside your system
.
3
Remove all the drives.
4
Disconnect all the backplane cables from the linking board and chassis management board.
84
Installing and removing enclosure components
