Dell EMC N2200, Руководство по началу работы

Страница: 24 / 38

22
• The Dell Networking switch booted successfully.
• The console connection was established, and the
Dell Easy Setup Wizard
prompt appears on the screen of a VT100 terminal or terminal equivalent.
The initial switch configuration is performed through the console port. After
the initial configuration, you can manage the switch from the already-
connected console port or remotely through an interface defined during the
initial configuration.
NOTE:
The switch is not configured with a default user name, password, or IP
address.
Before setting up the initial configuration of the switch, obtain the following
information from your network administrator:
• The IP address to be assigned to the management interface.
• The IP subnet mask for the network.
• The IP address of the management interface default gateway.
These settings are necessary to allow the remote management of the switch
through Telnet (Telnet client) or HTTP (Web browser).
Enabling Remote Management
The N2200-ON switch’s front panel contains a Gigabit Ethernet port of OOB
management. The OOB port is located to the right of the console port. On
the N2200-ON switches, you can use the OOB port or any of the switch ports
on the front panel for in-band management. By default, all in-band ports are
members of VLAN 1.
The
Dell Easy Setup Wizard includes prompts to configure network
information for the out-of-band interface on the N2200 switch. You can
assign a static IP address and subnet mask or enable DHCP and allow a
network DHCP server to assign the information.
See the CLI Reference Guide for information about the CLI commands you
use to configure network information.