Dell EMC 6WDJR, Инструкция по установке и обслуживанию, Страница: 93 / 129

2 Disconnect the power cable from the power outlet and from the PSU you intend to remove.
3 Remove the cable from the strap on the PSU handle.
4 Unlatch and lift the optional cable management arm if it interferes with the PSU removal.
For information about the cable management arm, see the system’s rack documentation at
Dell.com/poweredgemanuals .
Step
Press the release latch, and holding the PSU handle slide the PSU out of the PSU bay.
Figure 70. Removing a power supply unit
Next step
1 Replace the power supply units or Install the PSU blank .
Installing a power supply unit
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum output
power.
NOTE: The maximum output power (shown in watts) is listed on the PSU label.
3 Remove the PSU blank .
Step
Slide the PSU into the PSU bay until the release latch snaps into place.
Installing and removing system components 93