Delfield ST4427NP-6, Технические характеристики, Руководство по установке, эксплуатации и техническому обслуживанию

Страница: 22 / 28

22 Part Number: 9295093A 02/21
Maintenance Section 4
and do not require the use of tools or an authorized service
person. The gaskets are dart style and can be pulled out of
the groove in the door. Place gasket in warm water to make
the material more pliable for installation. Dry and press into
place.
PREVENTING BLOWER COIL CORROSION
To help prevent corrosion of the blower coil, store all acidic
items, such as pickles and tomatoes, in seal-able containers.
Immediately wipe up all spills.
Exterior Cleaning
,
Caution
Never use an acid based cleaning solution on exterior
panels! Many food products have an acidic content,
which can deteriorate the finish. Be sure to clean ALL
food products from stainless steel surfaces.
Clean the area around the unit as often as necessary to
maintain cleanliness and efficient operation.
Wipe exterior surfaces with a damp cloth rinsed in water to
remove dust and dirt from the outside of the unit. Always
rub with the “grain” of the stainless steel to avoid marring
the finish. If a greasy residue persists, use a damp cloth
rinsed in a mild dish soap and water solution. Wipe dry with
a clean, soft cloth.
Never use steel wool or abrasive pads for cleaning. Never use
chlorinated, citrus based or abrasive cleaners.
Stainless steel exterior panels have a clear coating that
is stain resistant and easy to clean. Products containing
abrasives will damage the coating and scratch the panels.
Daily cleaning may be followed by an application of stainless
steel cleaner which will eliminate water spotting and
fingerprints. Early signs of stainless steel breakdown are
small pits and cracks. If this has begun, clean thoroughly and
start to apply stainless steel cleaners in attempt to restore
the steel.
Wipe casters with a damp cloth monthly to prevent
corrosion.
Drawer Assembly Cleaning
The drawer assembly is designed to be cleaned easily. Both
drawer and tracks are removable without tools. The drawer
tracks are dishwasher safe or can be cleaned in a sink with
detergents and a soft bristle brush. Drawers and tracks
should be cleaned on a weekly basis.
Remove Drawers
Pull the drawer box out until it stops. Lift up on the drawer
front and pull the drawer box completely out. Using a soft
bristle brush, clean the track on the bottom of the drawer
box. When finished, it should be wiped clean of all food and
debris.
Tracks
The drawer box
assembly must be
removed. Pull the
drawer tracks out
until they hit a stop.
Locate blue safety
clips towards the
back of each drawer track. Blue safety clips have a tab on
the top. Push the tab back until it clicks. Lift up and pull
the drawer tracks all the way out of the drawer cage. The
drawer tracks are dishwasher safe or can be cleaned in a sink
with detergents and a soft bristle brush. Drawers and tracks
should be cleaned on a weekly basis. Using a soft bristle
brush, wash the track making sure each roller is thoroughly
cleaned. The drawer cage should be cleaned with a soft
bristle brush, removing any food and debris gathered on the
bottom ledge. Once it’s cleaned thoroughly with a soft bristle
brush, wipe remaining debris clean with a soft towel.
Reassembly
Push the drawer tracks into the drawer cage. The blue safety
clip must remain pushed towards the back. Lift up and slide
the drawer track all the way into the drawer cage. The blue
safety clip will lock in place automatically. Once all tracks are
replaced, insert the drawer box. Rest the drawer box bottom
track on the front track roller. Then push the drawer back
in place SLOWLY. When the drawer box is about half way in
you will hit a STOP. You must lift the front of the drawer up
approximately ½” (1.3cm) to continue inward. Clean tracks as
often as possible. The cleaner the tracks are the better they
will operate.
tab on top of blue
safety clip