Delfield SAH2-S, Руководство по эксплуатации

Страница: 19 / 32

19
Specification Line
Leveling
After the cabinet has been placed in the desired location,
cabinets with legs must be leveled. Level units from front
to back and from side to side. Leveling will insure proper
door operation and removal of condensate. Cabinets with
casters must have the caster brake set so the cabinet
cannot move.
Stabilizing
It is very important that all legs are properly adjusted to
keep the unit level, to evenly distribute the weight and to
make sure the unit will not rock, lean or be unstable.
Electrical Connection
DANGER
Refer to the amperage data list in the SPECIFICA-
TIONS or the serial tag data and your local code or
the National Electrical Code to be sure the unit is
connected to the proper power source. A protected
circuit of the correct voltage and amperage must be
run for connection of the supply cord or permanent
connection to the unit. The power must be turned
off and disconnected whenever performing mainte-
nance or repair functions.
CAUTION
Permanently connected units must be connected in
accordance with NEC Article 422 Appliances, C-Dis-
connecting means. It is the responsibility of the end user
to provide the disconnect means to satisfy the authority
having jurisdiction.
The power cords supplied with this equipment are three-
pronged plugs and must be connected to a three-pronged
wall outlet for proper grounding. Do not use an adapter
to connect to a two-pronged outlet. The three pronged-
outlet provides a ground connectio0n which must be
used to prevent a shock hazard.
CAUTION
Have the wall outlet check by a qualified electrician to be
sure a proper ground is present and that the outlet
provides the correct voltage and required amperage to
match the rating plate.
Any power cord that is frayed or damaged should be
replaced. When disconnecting the unit from the power
source, do not pull on the wire. Firmly grip the plug and
remove from outlet.
The plugs shown in Figure 5 are used on the various
models.
OPERATION
HEATED CABINETS
The Heated units have a POWER ON/OFF switch lo-
cated behind the flip up shroud at the front top of the unit
for controlling power to the unit and an electronic thermo-
stat for setting the temperature. A circulating fan pro-
vides uniform airflow in the cabinet. Refer to Figure 6 for
location of operating controls and proceed as follows:
1. Check that unit is properly connected to the
power source.
2. Raise the shroud to access the controls.
3. Set the Main POWER ON/OFF switch, to the
ON position.
4. Adjust the electronic thermostat to the desired
temperature.
5. Allow unit to warm-up before use.
DANGER
The unit surface is very hot! Avoid direct contact
with skin; use appropriate protective apparel, such
as gloves.
6. Turn the unit off by setting the POWER ON/
OFF switch to the OFF position
7. After use, allow unit to cool down.
8. Clean equipment as discussed in the MAINTE-
NANCE section of this manual.
Figure 5. Plug Configurations