Delfast NAC-CN90, Руководство пользователя

Страница: 13 / 16

11
delfast.com
TROUBLE
SHOOTING
TROUBLE SHOOTING
Fault & Cause Remedy
Charger gets hot, makes noise or starts to smoke.
CAUSE
•
The charger is damaged and should not be used.
• Unplug the charger immediately and replace it with
a new charger
Tool will not cycle, the indicator LED is green and the fan runs
•
Fuel cell is empty
• Spark wire is loose or dirty.
• Replace with a new fuel cell.
• Return to authorised service agent or manufacturer
for repairs.
Work contact element is not fully depressed and the tool
cannot be used.
•
The work contact element is bent or the track of the
safety mechanism is sticky, caused by dirt build up.
• Clean the safety track.
• If above does not work, return to authorised service
agent or manufacturer for repairs.
Tool operates normally, but no fastener is driven.
•
Wrong type of fasteners were used.
• Fastener is jammed
• The pusher did not engage
properly with the nail strip.
• The cylinder needs cleaning.
• Change to correct fastener specification.
• Clear the jammed nail before use.
• Adjust to full engagement.
• Return to authorised service agent or manufacturer
for repairs.
Combustion chamber is not returning to start position.
•
The work contact element is bent or dirty.
• Clean the safety track.
• Check the work contact element and have it
repaired
or replaced by authorised service agent or
manufacturer.
Driver did not return to initial position, high misfire frequency.
•
Issue with fuel cell.
• Tool is dirty.
• The tool may be over heated.
• Check and replace fuel cell.
• Clean the tool with proper cleaning fluid.
• Return to authorised service agent or manufacturer
for repairs.
Tool appears to be losing power.
•
Issue with fuel cell.
• The tool may be over heated.
• Check fuel cell.
• Return to authorised service agent or manufacturer
for repairs.
For failures other than above situation, please stop using the tool and contact authorised service agent or manufacturer.